![]() |
|
|||||||
| subscribed threads only |
|
| Event | By | Thread/Post | Forum |
New Post | TraceMills Today 07:20 PM | ||
New Post | inothome Today 07:20 PM | Had a good time today. Nice to see the familliar faces and meet some new ones too. (3,988 views, 207 replies) | |
New Post | Skips313 Today 07:13 PM | Hey Trace, hope your feeling better. STXR hull complete ready to sell. Its in VA but could be brought down to TJ for you. Follow the link above that 04RXP2 posted. If ya need need PM me and I can... (17 views, 2 replies) | |
New Post | WATER WOODY Today 07:13 PM | ||
New Post | HPI_Savage25 Today 07:10 PM | Sorry getting use to the forum gig, son hangs on them a lot for other stuff, my first time on one though. Sorry. Thanks wooop (0 views, 3 replies) | |
New Post | engineermike Today 07:09 PM | Jason, sorry we missed each other today. Apparently we crossed paths twice (I saw you the first time but didn't know it was you) today and still didn't meet up. I rode to the lake alone and back... (3,351 views, 156 replies) | |
New Post | dsolie Today 07:08 PM | That's what we did to our spare stock pipe a few years ago, used a dremel and A LOT of patience... Took 3mm out of the pipe entrance, and tapered it inwards 3".. Hits A LOT harder than stock, and... (247 views, 18 replies) | |
New Thread | RustySeaRustyDoo Today 07:07 PM | Asking for a friend who has a 99 GTI with the 720. He needs a tuned pipe, was curious on a replacement for the one he has that is broke or possibly an aftermarket pipe... Whats the best aftermarket... (0 views, 0 replies) | |
New Thread | Thomas Ellena Today 07:00 PM | Just would like to know for those of you who have changed your sponsons to R and D if you can really notice a difference in how the ski handles in the turns. I noticed today with the factory ones... (0 views, 0 replies) | |
New Thread | ph2ocraft Today 06:58 PM | ||
New Post | cfgp927 Today 06:57 PM | I will check the petals tomorrow....any known electrical problems with these machines???? The owner told me that he lost all his display information when the thing started running poorly late last... (23 views, 2 replies) | |
New Post | RX951 Today 06:55 PM | Cavitation and Vibration are the two most common symptoms. Get underneath your ski and with a flashlight, look in your pump inlet. Also look in the discharge side of your steering nozzle and see if... (15 views, 3 replies) | |
New Post | David_HX_RXP Today 06:54 PM | I have the entire OPAS system removed from my 2006 RXP. I am not sure if the Rudders are compatable with yours since the RXP version does not move up and down depending on speed (Jet Pump Pressure) ... (19 views, 1 replies) | |
New Post | Region8Ultra250X Today 06:53 PM | ||
New Post | Region8Ultra250X Today 06:50 PM | ||
New Post | 96XPSS Today 06:49 PM | Did you trailer it with the tank empty the last time you transported it? The bottom cap of the fuel pickup falls out when this happens, and the magnet & float falls out into the tank. Pull the... (19 views, 3 replies) | |
New Post | agibbs Today 06:48 PM | I've heard it is a very competitive closed course racing hull. There is a guy who did a conversion and put a turbo'd 215 engine into the hull. (44 views, 2 replies) | |
New Post | David_HX_RXP Today 06:46 PM | I have the PTO Tool (Solas WR-011 $10.00) and SD 4-Tec Crankshaft Locking Tool (529035821 $16.00) on order. My concern is more so reinstalling it to the Spec. 184lbs./FT. I could probably... (253 views, 14 replies) | |
New Post | 96XPSS Today 06:45 PM | The angle of the stock trim tabs dictate how much angle the hull will lift when trimmed all the way up. Too much causes porpoising. Shimming the rear of the tabs all the way accross the back will get... (123 views, 13 replies) | |
New Post | RX951 Today 06:44 PM |