Results 1 to 2 of 2
  1. #1
    Suthrn's Avatar
    Join Date
    Jul 2006

    R&D Rideplate install?

    The plate in untouched and straight out of the R&D packaging. In the directions it said I had to grind to install the plate but I read on this site that I wouldn't have to do that. I put the plate on and it does touch at the rear but it seemed to go on fine. Should I pull it off and grind some or will I be fine the way it is? It is an '06. Any help will be greatly appreciated so I can have all this done by riding tomorrow. Thanks.

  2. #2
    check your pm,,,

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Rideplate Installation
    By RobbieMWD in forum 4-Tec Performance
    Replies: 28
    Last Post: 01-24-2009, 09:29 AM
  2. 15f R&D rideplate install question
    By inchadeboca in forum Kawasaki PWC Performance (4-stroke)
    Replies: 1
    Last Post: 07-11-2008, 06:46 PM
  3. R&D RidePlate install
    By pottzr in forum Kawasaki PWC Performance (4-stroke)
    Replies: 1
    Last Post: 07-02-2008, 04:58 PM
  4. Rideplate install question...
    By GeoRXT in forum 4-Tec Performance
    Replies: 9
    Last Post: 08-05-2007, 02:35 PM
  5. R&D Rideplate Install Instuctions?
    By Chrisrokc in forum Yamaha PWC Performance (2-stroke)
    Replies: 12
    Last Post: 06-30-2006, 09:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts