Results 1 to 2 of 2
-
07-19-2005, 12:49 AM #1
- Join Date
- Jul 2005
- Location
- Coral Springs
- Posts
- 84
Throttle cable adjustment after finger throttle install?
Installed finger throttle.
When the manual states:
Ensure throttle body is fully open at full throttle
position.
At this position, throttle lever stopper is
almost in contact with throttle body.
How close is almost?
I should have checked for reference before hand.
Griff
-
07-19-2005, 02:49 AM #2
Mine's a knats chuff short (very very close!) half a mm at most..
I checked with a mates GTX SC (still using his thumb throttle) and his goes hard up to the stopper....
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Carb Adjustments after D-plate install
By lockone in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 07-09-2009, 09:54 PM -
Riva Finger Throttle Install Pics.
By WMFwatercraft in forum 4-Tec PerformanceReplies: 10Last Post: 12-22-2007, 10:14 PM -
Carb Adjustment After D-Plate Install????
By stepjl in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 09-13-2007, 06:47 AM -
throttle cable adjustment
By Snoman in forum Sea Doo Open DiscussionReplies: 5Last Post: 12-24-2006, 10:51 AM -
N/A 4 tec throttle cable adjustment
By Billd in forum 4-Tec PerformanceReplies: 2Last Post: 08-12-2006, 01:49 PM
I'm about to pull the trigger on buying a 2015 FXSVHO with 67hrs on the...
2015 Yamaha FXSVHO