Results 1 to 3 of 3
Thread: needle bearings on rebuild kit
-
07-15-2005, 06:26 AM #1
- Join Date
- Apr 2005
- Location
- Logan Township, NJ
- Posts
- 280
needle bearings on rebuild kit
I just got my rebuild kit for the SC and seen all those little needle bearings. I am not rebuilding the SC yet, but figured get the info now. Soo what is the best way to install all those little bearings and also rebuilding the SC. THanks for any help
Peter
-
07-15-2005, 07:59 AM #2
The replacement set of bearings should be held together with wax and a paper strip. Peel the paper strip off. Then wrap the bearings around the shaft right above the bottom ceramic disc.
-
07-15-2005, 08:00 AM #3
Peter, the needle bearing should have come on a wax backing. Just wrap that around the shaft and push them down into the gear area. (make sure you have 40 of them)
The wax coating melts away after initial startup.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
i need pump rebuild kit and thru hull bearings and seals
By lxman88 in forum Polaris Open DiscussionReplies: 36Last Post: 08-06-2014, 03:52 PM -
Supercharger bearings or whole rebuild kit?
By stickshift69 in forum 4-Tec PerformanceReplies: 24Last Post: 07-09-2014, 07:31 PM -
The 200 hr supercharger rebuild kits. Washers have a 1mm forming mark on the rim??
By lolzer in forum 4-Tec PerformanceReplies: 4Last Post: 08-07-2012, 01:36 AM -
I need help on installing a pump rebuild kit.
By Timfd024 in forum Polaris Open DiscussionReplies: 1Last Post: 09-15-2011, 11:16 AM -
question on the 08 rebuild kit with metal washers.
By Promod1955 in forum 4-Tec PerformanceReplies: 5Last Post: 08-08-2009, 11:54 PM
No it would not throw a code as it ia just a failed part of a normal...
2008 FX SHO - No Start - No...