Results 1 to 2 of 2
  1. #1
    xyzyx00's Avatar
    Join Date
    Jan 2006

    intermediate shaft swap-out

    swapped out the whole pump/driveshaft setup on my 02 today, including the intermediate shaft (used, not new) -- should i put any kinda sealer inbetween my intermediate and the wall, or would it be good bolting it back on as is? id hate to have a leak after the motors back in....

  2. #2
    Hydrotoys's Avatar
    Join Date
    Jul 2005
    Mesa, AZ
    Can't see why it would hurt to use a little. I've never used any, and I don't remember the book say to use any.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How do you get the intermediate shaft out of housing?
    By boostcrazy99 in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 06-30-2016, 08:49 AM
  2. Rxt drive shaft 05/06 hull insert swap out
    By MARTYP in forum 4-Tec Performance
    Replies: 13
    Last Post: 06-20-2012, 08:24 AM
  3. Intermediate Shaft Removal
    By njgprider in forum Yamaha How To & FAQs
    Replies: 5
    Last Post: 08-22-2006, 04:25 PM
  4. Swapped out GTX shaft for RXT shaft
    By Red Devil in forum 4-Tec Performance
    Replies: 15
    Last Post: 10-26-2005, 12:40 PM
  5. Swapping out Impellers
    By Red Devil in forum 4-Tec Performance
    Replies: 15
    Last Post: 06-20-2005, 11:48 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts