Are these clutch wahsers the the coated......

[Jrsrxp]

Are these washers the coated ones and do Jerry carry them in the online store. When instaling them what is the life befor they slip or they have to be shimed.


http://www.seadoocentre.com/hardened_clutch_washers.htm

[Green Hulk]

Yes, those are the coated ones.

The washers i will be stocking very soon are non coated.

[Jrsrxp]

So the coated wassers will need to be shimed after a few hours of run time??? What is the big diffrent and what is the live of the berrings? i had one to go out last year and do not want another trashed SC and Housing??

[Green Hulk]

All washers, coated, or ceramic run the potential of having to be shimmed after some run in.

Nobody can put a time limit on bearing, etc.

A good rule of thumb would be to completely rebuild your SC every 80-100 hours.

[Kinchyle]

I remember you saying you will be selling a kit.
I believe it was the washers and springs.
Will it contain bearings too ?
What happens if the bearings go out ?

[jawz]

Bearings going out is as bad or worse than ceramic cluthes gone!

[HOSS]

Yeah,, impeller eats housing!

[Green Hulk]

No, that has changed. I will only be selling the washers.

[Kinchyle]

Bearings going out is as bad or worse than ceramic cluthes gone!

Is it common for the bearings to go out, as common as the washer ?

Is the RR hydrolic full proof ?
All this SC blowing up talk makes me just want to get ones of those and forget about it.

[Green Hulk]

No, bearing failures are not as common as ceramic failures, but they do occur. Rebuld your SC every 80-100 hours to be on the safe side and remember..... NOTHING is foolproof.