94 slt750 gas cap

[mrvb1969]

My gas cap on the 94 stl750 has split almost all the way around the cap where it threads onto the filler tube. Is there anything that I can use to repair this? I have tried epoxy, super glue, and JB weld. None have held (I belive this has to do with gas saturation in the cap). If this is not repairable, does anyone have the larger style cap, or know where I can get one?. I have ordered two off of ebay and they have both been the smaller diameter.
Thanks,
Mike

[ph2ocraft]

I installed the much newer style on my SLTX, it just requires a little work to make it fit but then you have a better sealing cap. Your dealer should be able to get you the replacement assembly for your 750, it'll be black versus the original blue.
INLET ASM,FUEL CAP
2872029 (replaces 5431606-196)

[ph2ocraft]

This is the newer style. You'd have to drill out the rivets (you have to in order to replace it anyway),seal them up and install.

[785 lugs]

check ebay the Seadoo cap and neck will fit also the ones that look like Al pictured ,there much easier to find also .
http://cgi.ebay.com/ebaymotors/Seadoo-gas-cap_W0QQitemZ150261008570QQihZ005QQcategoryZ124111 QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

there nice because they come in different colors also ,theres a bunch on ebay right now cheap too

[mrvb1969]

Good thing is one of the ones I received from ebay was the newer style pictured(also came with the neck), but if i remeber correctly the neck doesn't fit the filler tube going down to the tank.

[785 lugs]

it will fit you may have trim it back alittle