Results 1 to 3 of 3
-
06-21-2008, 06:27 PM #1
RXT piranha IC /4 in intake install
After installing the Piranha IC and 4 inch intake, the IC hoses and intake were up against each other.
Looking at the IC sitting on the bracket there is a little more than 1/2 inch between the top of the IC and hull.
Has anyone placed a spaced between the IC and bracket?
I wonder if its enough to create enough space so the pipes aren't touching.
Any thoughts?
-
06-21-2008, 09:40 PM #2
- Join Date
- Mar 2007
- Location
- Perth, Western Australia
- Posts
- 194
- +1
- 1
The four inch intake hose along with the pirahna ic hoses is a bit of a snug fit.. Im fitting 3.5 inch intake hose instead so it isnt as snug, i know its better to run the 4 inch but im only a rec rider not a hardcore racer
-
06-21-2008, 10:08 PM #3
Thanks for the info.
I may consider a 3.5 intake if I opt for stainless steel piping for the IC.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Easy; Can stock IC and Exhaust clamps be reused after Riva Air intake install???
By Mikey G. in forum 4-Tec PerformanceReplies: 1Last Post: 07-01-2008, 02:44 PM -
looking for Piranha IC install pictures
By bruinsrme in forum 4-Tec PerformanceReplies: 10Last Post: 06-24-2008, 05:43 PM -
RXT Riva 3" Intake Install
By Antiguan FZR in forum 4-Tec PerformanceReplies: 4Last Post: 09-05-2007, 10:42 AM -
Riva Intake install ? RXT
By sourpower RXT in forum 4-Tec PerformanceReplies: 4Last Post: 07-08-2007, 06:24 AM -
IC in Intake (not stock)
By Tube Master in forum 4-Tec PerformanceReplies: 27Last Post: 01-21-2006, 01:12 PM
I had a 2016 fx ho model weigh about 200lbs and I could go 150 miles or...
Range of PWC with Added Weight