Results 1 to 2 of 2
Thread: Pre Mix Question
-
06-13-2008, 11:09 AM #1
- Join Date
- Jun 2008
- Location
- Hamburg New Jersey
- Posts
- 30
Pre Mix Question
I recently replaced a cylynder jug in my 2000 gp 1200 and when I went to bleed the oil line nothing happened. So I assume the pump is bad. So I will be mixing the oil and the gas in the tank. My question is how much oil should I put in my fuel tank assuming it is close to empty. I think my take is 12 or 13 gallons.
-
06-13-2008, 11:15 AM #2
- Join Date
- Aug 2007
- Location
- Richmond, TX (near Houston)
- Posts
- 25
Try this. It was posted on here. Hope it helps.
http://greenhulk.net/forums/showthre...mix+calculator
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
93 polaris pre mix questions
By freemandino25 in forum Polaris Open DiscussionReplies: 3Last Post: 08-15-2010, 09:52 AM -
converting to pre-mix at rebuild question
By toyterrific in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 07-19-2010, 08:03 PM -
Pre mix questions
By FASTRTHNU2 in forum Yamaha PWC Performance (2-stroke)Replies: 35Last Post: 06-09-2010, 08:03 AM -
Pre-Mix Question - Rotarvy Valve Lubrication
By kidafa in forum 2-Stroke PerformanceReplies: 6Last Post: 07-17-2009, 06:30 AM -
Going Pre-mix....Question
By rob2337 in forum Polaris Open DiscussionReplies: 3Last Post: 08-27-2007, 11:20 PM
I'm considering a new WaverRunner, the FX HO model and read here the range...
Range of PWC with Added Weight