Anyone have pics of RXP-X with Seatcover?

[twinturbostang]

Anyone have pics of RXP-X a with Seatcover on it? I ordered one this week but there is a little wait so I would like to see a pic of one on the ski to know what i am in for.

[ctriverguy]

Its the jetrim, instead of orange i went with silver

[twinturbostang]

Looks good. When/where are you out on the river?

[t_hoang02]

ctriverguy,

you have the same setup as i do... an 08 rxp-x and a 05 rxt (green)... where did you get the seat cover from and how much... and is that the seat cover for the RXP?? because i wonder if the were the same...

[twinturbostang]

The one I ordered was right here on this site.
http://www.4-tecperformance.com/inde...ex&cPath=18_14
I got the one that is for the RXPX with the orange on it. I will post pics once it shows up.

[ctriverguy]

this is where i puchased mine. At the time, jerry wasnt carrying them.

http://www.jettrim.com/products/inde...d=11&imgid=249


There looks like a few other new choices as well. check em out.


the rxt is now full stage 2 with s3 wheel. thing pulls like a champ, highly recommend the mods.

[salsa]

Hey Riverguy, I just got my Jettrim cover today. It's nearly the same as yours, but I went with the gunmetal on the sides and back. I chose the logo as well. How was that to install? DIY or upholstery shop? By the way, your ski looks really nice and clean with the stickers removed.

[ctriverguy]

Hey Riverguy, I just got my Jettrim cover today. It's nearly the same as yours, but I went with the gunmetal on the sides and back. I chose the logo as well. How was that to install? DIY or upholstery shop? By the way, your ski looks really nice and clean with the stickers removed.

I did it myself, it was easy but you must have a pneumatic stapler, a regular staple gun wont do it. start with the front and back dead center and work your way around, there is a set of directions on the jetrrim page you can print out. MAKE SURE you are dead center!!

[salsa]

When I ordered mine I asked the gal on the phone if you remove original cover or go over it. She said remove and put down heavy plastic as these covers will take on water and get heavy. What did you do?

[kp04rxp]

jettrim instructed me to leave the oem cover on and install the new cover over top... Make sure you use stainless steel staples.