Results 1 to 2 of 2
-
06-29-2006, 05:57 PM #1
Adding thin head gasket to Riva Stage 3 Setup wise or pushing it
I know stage 3 parts havent been released yet but considering the setup would adding compression be beneficial to it. My experience with boost is that lowering compression and raising boost always gives the best results meaning leaving it the way it is would be best. If we bumped up the compression which isn't much with the gasket do you think it would help out or maybe slow it down, cause detonation, have to run better gas, etc. just trying to find some theory before trying it out.
-
06-29-2006, 06:25 PM #2
I wouldn't mess with it.
Im going to put the Stage 3 on Careys ski. That stock head gasket is staying on.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Which head gasket to use?????????????
By rxpvic in forum 4-Tec PerformanceReplies: 19Last Post: 03-25-2012, 09:25 AM -
What is the best Head gasket to use
By Speed796 in forum Yamaha PWC Performance (2-stroke)Replies: 12Last Post: 02-14-2007, 10:46 PM -
Up grading to Riva stage 3
By GRNGOBLIN in forum Sea Doo Open DiscussionReplies: 3Last Post: 06-05-2006, 07:53 PM -
RIVA Stage 1 installed! Down to 7700 RPMs. Any pointers?
By sgaaap in forum 4-Tec PerformanceReplies: 15Last Post: 10-01-2005, 10:56 AM -
Riva Stage 1 kit (how long does it take to install)
By macattack in forum 4-Tec PerformanceReplies: 7Last Post: 06-20-2005, 04:10 PM
Check the camshaft timing marks with the crank at tdc compression#1, make...
Help, 2019 fx svho stage 2 with...