Results 1 to 2 of 2
  1. #1
    thompsdw's Avatar
    Join Date
    Sep 2007
    Richmond, VA

    Cable Tie Mount Blocks that Glue In

    In the '98 vintage seadoo made cable tie mounts that you could glue into the hull and hang wires from. The bottom of the mounts had somthing that looked like channels so you could push it into the adhesive for a better bond. I have wanted some of these on many occasions and can not find them.

    Does anyone know where to get these glue blocks?

  2. #2
    David 1 FAST VE's Avatar
    Join Date
    Jun 2005
    Southaven, MS
    Home Depot and Lowe's both has them in the electrical section with the tie wires.
    They have a sticky back that you must remove and then epoxy it to the hull.
    Make sure you slide a tie through while the epoxy is wet so it does not clog up the hole.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Laws that get in the way of common sense..
    By HAZE in forum Open Discussion
    Replies: 18
    Last Post: 10-02-2009, 11:11 PM
  2. RXP Reverse Cable Pump Mount
    By RXPRacer513 in forum 4-Tec Performance
    Replies: 0
    Last Post: 04-26-2009, 05:51 AM
  3. Remember that jet ski that sat in the water for 6+ months?
    By SlowStang305 in forum Open Discussion
    Replies: 18
    Last Post: 01-22-2009, 01:54 AM
  4. Is that Shibby in PWC illustrated?
    By Jeff C in forum Sea Doo Open Discussion
    Replies: 4
    Last Post: 09-04-2006, 08:47 PM
  5. im trying to find the seal that is in the pto cover
    By rapidacceleration in forum 4-Tec Performance
    Replies: 3
    Last Post: 02-25-2006, 11:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts