Results 1 to 6 of 6
-
06-05-2008, 08:46 PM #1
- Join Date
- Mar 2008
- Posts
- 223
Little hole repair inside the riding area?
Little hole repair inside the riding area? I have never dropped anything on the floor of my speedster 150 that is only 3 months old, but I noticed a small hole the size of a dime on the floor near the seat area .I was ridding for the first time in ruff seas where I felt the boat shake hard with some good waves. Could that happen? anyway I have to fix it ,so what do I use that will last and look like I never didi it. Thanks
-
06-05-2008, 10:24 PM #2
- Join Date
- Feb 2008
- Location
- Raleigh, NC
- Posts
- 67
Would you mind posting a pic? That sounds really strange.
-
06-06-2008, 07:15 PM #3
- Join Date
- Mar 2008
- Posts
- 223
I'm just wondering if this is something that will get worse of if I should bring it to the dealers attention,or they'll just try to say I didi it. Any advice?
-
06-06-2008, 07:48 PM #4
-
06-06-2008, 09:07 PM #5
If it would be covered by a warranty let the dealership worry about it.....
-
06-06-2008, 09:56 PM #6
- Join Date
- Apr 2008
- Posts
- 9
Tough call, but I'd let the dealer check it out before I did anything. Could be a warranty issue.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
04 RXP broken hex nut supercharger bracket inside the mag area next to timing ???
By ruinplay in forum 4-Tec PerformanceReplies: 6Last Post: 09-19-2014, 10:19 AM -
stupid question with regards to filling the ride plate holes
By 206 in forum 4-Tec PerformanceReplies: 1Last Post: 06-24-2008, 04:48 AM -
Where is the thread on how to fill the ride plate holes?
By EAG8999 in forum 4-Tec PerformanceReplies: 1Last Post: 05-21-2008, 01:59 PM -
Crack in Gelcote inside the impeller shaft area...
By yellow4 in forum 4-Tec PerformanceReplies: 10Last Post: 07-16-2007, 10:15 AM -
Filling the ride plates holes
By somefun in forum 4-Tec PerformanceReplies: 5Last Post: 05-07-2006, 11:24 PM
I'd start by checking the fuses on the MPEM. Had a 5A go bad on a GTX a...
Seadoo GTI LE issues