Results 1 to 3 of 3
  1. #1

    Join Date
    Aug 2007
    Tucson, AZ

    Primer nipple too small

    I bought a primer kit for my 93 SJ and the plug fits fine but the nipple is a bit small and slides out. Is there something I can use to get it to stay in?

  2. #2
    I had it happen on a few ! use red loctite or if it's real loose use jb weld
    Last edited by ZMANN; 06-03-2008 at 03:50 PM.

  3. #3

    Join Date
    Aug 2007
    Tucson, AZ
    I tried the red loctite unsuccessfully. JB weld it is. Thanks.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. help with rear tie downs. trailer too small.
    By fivespeedsteed in forum Towing and Trailers
    Replies: 8
    Last Post: 08-28-2012, 10:20 AM
  2. Impeller too small for wear ring housing
    By dittobell in forum Kawasaki PWC Performance (4-stroke)
    Replies: 12
    Last Post: 10-03-2010, 07:16 PM
  3. Replies: 4
    Last Post: 07-08-2010, 07:21 PM
  4. hull reinforcement kit seems too small
    By Purple Haze in forum Yamaha PWC Performance (2-stroke)
    Replies: 8
    Last Post: 05-18-2006, 11:20 PM
  5. When is a boat too small ?
    By RX951 in forum Yamaha Open Discussion
    Replies: 13
    Last Post: 05-12-2006, 11:31 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts