Any free mods for the 250x?

[r103]

I have 07 250x with Riva ride plate 2 wedge. It will run 69.5 all day long. I was wondering if there are any "free mods" air intake, hole in the seat, anything like that.

Thanks Wes

[spaulding]

pull the cover below the glove box and pull the hoses from the intake

http://greenhulk.net/forums/showthread.php?t=59505

this will get you very close or to 71

[TEEBEE]

pull the cover below the glove box and pull the hoses from the intake

http://greenhulk.net/forums/showthread.php?t=59505

this will get you very close or to 71

Can you snap a few pics of the hoses and the cover your talking about?

[r103]

Can we get some pics and where did you get the u-bend pipe?

[spaulding]

The cover to replace is directly below the glove box. The u-pipe can be found on ebay or any exhaust pipe vendor on the internet. 2.25 stainless u-bend. R-rated sells a u-bend kit for the 07s, get theirs it is designed to fit and clamps.

The hoses to remove are on your stock intake and run from the valves on the intercooler to the stock air intake.

Do all of this at your own risk, but for less than $50 after shipping and some time the improvements are well worth it.

[blownhotrodder]

I got my u- pipe off ebay too. Cheap.

[JET250]

I got my u- pipe off ebay too. Cheap.

+1