What are some simple mods for the 2008 Wake?

[skyline99k]

I was wondering wat are some simple mods to boost up some speed because my bro (evo8coop) and I are only running about 7900rmps on it?

[DarthAWM]

Tweak the prop(-1mm maybe 2), fill ride plate holes, 3/4"x2" PVC opas block ups. Those are free or close to it.

Low buck add a wedge (2 or 2.5 doesn't matter too much), do a kanoflex 4" intake, Riva intake grate, or even a gibson.

[jcoop421]

ok do they have instructions on how to do that stuff lol. Our best run was 64.1 done by me not my brother. I just can seem to get it past 7900 rpms, can that be because i didnt break it in right.

[DarthAWM]

ok do they have instructions on how to do that stuff lol. Our best run was 64.1 done by me not my brother. I just can seem to get it past 7900 rpms, can that be because i didnt break it in right.

Don't feel like the lone ranger, 7860 is the best I've seen on my GTX. There are instructions on the ride plate holes and prop bending in the How to forum. The block ups are easy: you take section of 3/4" PVC pipe cut off two 2" long pieces from it, (I used a coping saw be cause its small and manuverable, but any wood saw will work fine) then you cut a vertical(length wise) slot about 3/8-1/2" wide in them. To install you push the OPAS into the up position then work the pipes into place(I used a hammer to gently tap them into place afte getting them started)

[04RXP22]

Free flow exhaust is good for 50-100 RPM.

[skyline99k]

ok thanks

[jcoop421]

darthawm what was your best stock speed is that it in your sig?

[DarthAWM]

darthawm what was your best stock speed is that it in your sig?

Yep.

[iceman1998]

Filling the holes in the ride plate will give you better top end? Somthing that small?

Chris

[skyline99k]

thanks