Results 1 to 1 of 1
Thread: Reverse Cable help
-
05-30-2008, 04:06 PM #1
Reverse Cable help
I put a ride plate and a pump wedge on and got it all installed and went to pull the reverse handle down and it cracked the handle and made a weird screeching noise. I can pull the reverse down with the handle but when i got to push the handle back it gets stuck about halfway down and i have to go around the back and pick the reverse bucket up by hand. The weird thing is nothing was scrubbing but I have no clue what to do any suggestions?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Need help with broken reverse cable on Yam 1200 SUV
By WaterDR in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 06-06-2013, 10:48 AM -
Help with 2004 R-12 reverse cable nut???
By mikel1 in forum Honda Open DiscussionReplies: 5Last Post: 05-27-2013, 03:19 PM -
06 RXT Reverse Cable Help
By 83Gator in forum Sea Doo Open DiscussionReplies: 4Last Post: 11-21-2011, 10:04 AM -
Help: reverse cable nut stuck when pulling pump shoe / pump support
By sweetbats in forum 4-Tec PerformanceReplies: 2Last Post: 07-05-2010, 02:58 PM -
Help with Reverse cable repair
By Foggy in forum Kawasaki PWC Performance (4-stroke)Replies: 1Last Post: 06-30-2008, 01:35 PM
14's were in the greatest failure period. A ways back, I did a...
2014 FZS