Results 1 to 4 of 4
-
05-29-2008, 01:44 PM #1
How do I get 06 STX15F out of SLO mode?
Ive got an 06 STX15F that i think is in SLO mode because it wont go above 5k RPM and 45mph. I can't figure out how to get it out of SLO mode. Any help is appreciated.
-
05-29-2008, 01:54 PM #2
hold down the mode button on the dash for like 10 sec, or until you see the display reset. if that doesnt work, hold down both buttons on the dash until it resets. sry, but i dont remember exactly what one it is.
-
05-29-2008, 02:34 PM #3
Does it matter if the ski is running or not? I tried holding in the mode button this morning for atleast 20 sec. if not more, and all that happens is that it starts scrolling through the hours, miles, time, trip, etc. and keeps repeating.... ill try it again this afternoon though.
-
05-29-2008, 08:45 PM #4
umm, i know you can do it w/ the ski on. or using the little orange key thing, turn it off the back on, then try holding down the buttons. thats how mine changes between the modes
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How can I get my MSX110 out of limp mode?
By andyne in forum MSX/MatrixReplies: 3Last Post: 06-06-2014, 11:04 PM -
HELP!! How do you get the midshaft out of my 95 700 waveventure???
By killerk in forum Yamaha Open DiscussionReplies: 0Last Post: 06-20-2013, 10:00 PM -
newb question. how do you get the inserts out of the back deck?
By h2jim in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 10-16-2012, 07:44 PM -
How do you get wear ring out of plactic pump
By 111toybox in forum 4-Tec PerformanceReplies: 5Last Post: 08-06-2012, 07:14 PM -
How do you get the water out of the hull bottom?
By BrAinZ in forum Sea Doo Open DiscussionReplies: 8Last Post: 06-02-2006, 09:03 PM
I would pull the engine and try, try again..
Finally rebuilt (300 conversion)...