Results 1 to 4 of 4
-
05-28-2008, 02:32 PM #1
Jerry's rebuilt SC goes in today, do I ...
... need to slather or lightly oil the SC washers/gear before putting it in? and of course add the anti-seize ... any other to-do's?
Thanks all!
-
05-28-2008, 02:34 PM #2
Just pour some engine oil on the clutch assembly and some anti seize on the hub and slap her in there.
-
05-28-2008, 05:04 PM #3
You guys do not put 243 Loctite on the nut threads (impeller nut to shaft and clutch side nut to shaft)...?
I use to do it....but never used the red one....was abit concerned about the red being a little too hard to remove compared to the blue one.
-
05-28-2008, 05:10 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Finished oil change. When rxt goes in water it dies.
By acesea in forum Sea Doo Open DiscussionReplies: 23Last Post: 06-17-2007, 05:27 PM -
I dropped my engine in today
By Green Hulk in forum 4-Tec PerformanceReplies: 46Last Post: 05-03-2006, 06:37 AM -
My engine came in today *pics*
By Green Hulk in forum 4-Tec PerformanceReplies: 47Last Post: 04-14-2006, 10:49 PM -
Began my break in today
By meirvin in forum Sea Doo Open DiscussionReplies: 7Last Post: 03-03-2006, 10:27 PM -
My new RXX hood came in today
By Green Hulk in forum 4-Tec PerformanceReplies: 29Last Post: 10-27-2005, 01:43 PM
BTW - it's easy to tell if the cam holder is the one that came with the...
2013 15F head replaced now exhaust...