what hole saw are you using

[bruinsrme]

I have now cut 2 holes in my ski.

In the past Lenox has been my brand of preference for hole saws.

The other day a 3 inch hole saw blade was not to be found so a RIGID (home depot) bimetal was used in place of a Lenox. I have to say the rigid hole saw bit made an EXTREMELY clean hole. No chips whatsoever.

[Turbo Todd]

If You Want To See A Real Nice Hole Try Drilling A Hole On The Bottom Of Hull.it Does A Great Job Trust Me.your Friend For Life.todd

[aha]

mine is a non brand kit from harbor freight. Works great imo.

[ctriverguy]

I support lenox, good products, grate blades...(my buddy works there, and he gives me free stuff )

[lafjax]

I have now cut 2 holes in my ski.

In the past Lenox has been my brand of preference for hole saws.

The other day a 3 inch hole saw blade was not to be found so a RIGID (home depot) bimetal was used in place of a Lenox. I have to say the rigid hole saw bit made an EXTREMELY clean hole. No chips whatsoever.

Geez, that looks familiar!!

[bruinsrme]

If You Want To See A Real Nice Hole Try Drilling A Hole On The Bottom Of Hull.it Does A Great Job Trust Me.your Friend For Life.todd

Think you been breathing in too much of that fine paper mill air...

[bruinsrme]

Geez, that looks familiar!!

that is what happens when I get bored.

Hey Larry thank you for the material muchly appreciated.

Have an idea for that filter. waiting on a part.

I had the part but ran it over with my truck, again bored.

[kp04rxp]

pretty sure mine was a rigid metal whole saw (smaller teeth) It has done a great job for 2 rear exhaust holes.. 2.75" tho