Results 1 to 4 of 4
Thread: Re-installing SC?
-
05-25-2008, 01:59 PM #1
Re-installing SC?
I've sent my SC to Jerry to have washers installed in it.......When i get it back and go to install it back in the ski is there anything i should do before i bolt it back up? Grease shaft? etc?
Thanks,
Chris
-
05-25-2008, 02:01 PM #2
I use a small amount of grease around the O rings to aid in installation. Just be sure the SC is seated, if it is not just a slight turn of the impeller and you should be good to go.
-
05-25-2008, 04:37 PM #3
Ok....i noticed a little bit of grease right around where the back of the SC housing meets the block.....I didn't know if i need to re-apply more grease before i reinstall the SC.
Chris
-
05-25-2008, 04:40 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Waterbox Re-install
By badams7 in forum 4-Tec PerformanceReplies: 1Last Post: 04-02-2007, 11:24 PM -
Supercharger Re-Install
By badams7 in forum Sea Doo Open DiscussionReplies: 9Last Post: 03-26-2007, 06:47 PM -
Supercharger Re-Install?
By Suthrn in forum 4-Tec PerformanceReplies: 6Last Post: 03-26-2007, 06:44 PM -
re-installing SC
By rxpblast in forum 4-Tec PerformanceReplies: 7Last Post: 10-06-2006, 09:12 PM -
Anyone had PPG install SC clutch?
By rx4pain in forum 4-Tec PerformanceReplies: 8Last Post: 07-21-2005, 06:19 PM
I had all Mikuni parts and had similar issue. I did gently stretching on...
Carburetor Pop-off pressure when...