Results 1 to 9 of 9
Thread: ME the Bone head
-
05-22-2008, 08:21 PM #1
- Join Date
- Apr 2005
- Location
- Augusta GA
- Posts
- 720
ME the Bone head
After spending the last two day working on my 04 RXP after the SC went out and diging into the motor to find the Ring gear teeth broken and trash and gunk in the moto from the SC and and getting parts overnighted. Got eveything back together with the help of the guys here at the dealer. Bolted everything back up started the motor and guess what the nut on the gear end of the SC I for gotten to............... yep you guess tighten it
. @#$#$% @#&*$% every curse word and even some i made up. I was in luck the nut did not come off and I did not lose any of the parts off the SC. Tighten it back down and ready to roll. Whe weeee had to get that out.
-
05-22-2008, 08:39 PM #2
-
05-22-2008, 08:43 PM #3
-
05-22-2008, 08:56 PM #4
- Join Date
- Apr 2005
- Location
- Augusta GA
- Posts
- 720
Trash that was not clean out. When I lost some needle and ball bearings last September got caught in between the gear and sheared off some teeth. Did not do a good job of cleaning out the trash. Will post soem pics
-
05-22-2008, 09:17 PM #5
- Join Date
- Apr 2005
- Location
- Augusta GA
- Posts
- 720
Whats wrong with these pictures???
-
05-22-2008, 09:19 PM #6
-
05-22-2008, 10:10 PM #7
bearing failure on that SC?
-
05-23-2008, 05:45 AM #8
- Join Date
- Apr 2005
- Location
- Augusta GA
- Posts
- 720
The berring was gone and the shaft was bent. I think the ring gear missing teeth and not riding on the SC gear is what cause it was warp, picking up trash and riding funny causing the sc to go south. what you think???
-
05-23-2008, 09:32 AM #9
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What is the best Head gasket to use
By Speed796 in forum Yamaha PWC Performance (2-stroke)Replies: 12Last Post: 02-14-2007, 10:46 PM -
so im new, tell me the basic mods on the rxp please
By flyn ryan in forum 4-Tec PerformanceReplies: 9Last Post: 03-19-2006, 07:21 PM -
Hulk can you PM me the cost of paint change
By bling bling in forum 4-Tec PerformanceReplies: 14Last Post: 05-03-2005, 06:55 PM
If it has a d plate installed on it than you need to make a “chip” for...
1300R, exhaust beeping.