Results 1 to 4 of 4
Thread: Lower RPM's on one engine
-
06-19-2006, 05:15 AM #1
Lower RPM's on one engine
Guy's took the boat out on Sunday and I noticed that one motor was down about 200 RPMs. I know the first thing to check is the boost so I'm going to pull all that apart and reseal it. But just to make sure how do you check for SC slippage? Is it as easy as putting a torque on the SC nut? If it was the clutch does 200 sound right to be low? (I'm sure it’s hard to say) What should it be for slippage? I'm thinking of doing the boost gages but if I don't have the IC block off where should I put the sender?
-
06-19-2006, 09:04 AM #2
I would look at the wear ring first.
-
06-19-2006, 09:29 AM #3
Just put new SSJust put new SS rings in it maybe 5HR on them.
-
06-19-2006, 10:24 AM #4
I lost anywhere from 400 to 600 rpm when my supercharger outlet coupler leaked...which btw, happened 4 times yesterday
Need to come up with a better I/C bracket.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Removing the rpm limiter on yamaha fx cruiser svho engine 2015
By Nutcase in forum Yamaha Open DiscussionReplies: 7Last Post: 05-05-2016, 03:29 PM -
2000 slh 700 red engine. Any one have Torque specs on the engine?
By hotbird in forum Polaris How To & FAQsReplies: 1Last Post: 09-09-2012, 09:01 AM -
1998 Challenger 1800 help!! One Engine is b0gging other won't excedd 400 RPMS
By djmikeb in forum Sea Doo Sport BoatsReplies: 1Last Post: 05-18-2011, 09:14 PM -
Wierd problem. Lost RPM on ONE motor
By espenursin in forum 4-Tec PerformanceReplies: 5Last Post: 06-29-2008, 06:41 PM -
Low RPM's on one motor
By somefun in forum Sea Doo Sport BoatsReplies: 9Last Post: 03-03-2007, 12:17 PM
I rode it hard today for a couple of hours. Lots of WOT runs but for only...
I just bought a 2002 1200 STX-R....