Results 1 to 3 of 3
Thread: Water box EGTS sensor
-
05-15-2008, 07:16 PM #1
Water box EGTS sensor
Someone here thought their sensor on the water box was failing.
With an ohm meter the resistance should be 2280 to 2820 ohms.
-
05-16-2008, 04:35 PM #2
That was me. Thanks for the feedback. If you get a chance, measure across your intake manifold temp. sensor located on the front of the intake & tell me what you get. I found out that the PO 127 fault code on the X boats equates to high intake air temp. fault. Thanks for the help.
Doug
-
05-16-2008, 05:04 PM #3
I will try to get to this tomorrow, hopefully I can find it.
Its pouring out right now.
Scott
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WTB 4tec COIL and inetercooler block off CLAMP and water box SENSOR
By dlamazing in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-19-2011, 10:31 AM -
Water Box Mods!
By Angelse68cal in forum 4-Tec PerformanceReplies: 12Last Post: 08-05-2005, 01:39 PM -
water box mod ?
By Krazy-K in forum 4-Tec PerformanceReplies: 1Last Post: 07-26-2005, 06:59 PM -
water box mod
By peter in forum 4-Tec PerformanceReplies: 7Last Post: 07-09-2005, 10:52 AM -
Water Box Mod
By Red Devil in forum 4-Tec PerformanceReplies: 27Last Post: 05-17-2005, 04:56 PM
I have to Run to Harbor freight to get torques socket I think I need a 8...
2007 rxp