Results 1 to 2 of 2
Thread: worked on the ski today
-
05-14-2008, 05:08 PM #1
- Join Date
- Aug 2007
- Location
- Sparrows Point, MD (near the Key Bridge)
- Posts
- 999
- +1
- 22
worked on the ski today
Installed a water strainer and shut off valve, plus some other things, pics below. Also was testing possible intake locations. Question I had was has anyone run the supply hose to the inner cooler under the opposite side (intake side) of the engine that it normally runs (exhuast side). If anyone thinks it might be a problem let me know so I can change it then.
-
05-14-2008, 06:31 PM #2
I see in your picture that you put like 4 inch pvc to hold straps tight. Does anyone think it would be bad to just strap the intake hose underneath the straps. It didn't seem to flex to much and it held the hose nice and tight?
Nice mods and clean install on the strainer.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Went to work on the ski, hit a snag right off the bat...
By burtonrider10022 in forum Polaris Open DiscussionReplies: 3Last Post: 07-10-2013, 05:53 PM -
...:did some work on the ski today:...
By my00b16si in forum Yamaha PWC Performance (4-stroke)Replies: 13Last Post: 05-18-2009, 01:06 PM -
Worked on the ski now I have some questions
By sfackett0 in forum 4-Tec PerformanceReplies: 8Last Post: 11-03-2008, 10:32 PM -
Time to work on the bottom of the ski
By mrbtd in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 06-15-2007, 09:03 AM -
Riding Hours vs Working on the Ski Hours
By jack in forum 4-Tec PerformanceReplies: 12Last Post: 11-27-2005, 03:39 PM
Any suggestions appreciated. Running injector cleaner and doing spark...
2014 310x bog full throttle off...