Results 1 to 4 of 4
-
05-13-2008, 01:03 PM #1
Steering cable ball joint torque?
can`t seem to find the tightening torque for the ball joint at the steering nozzle. I`m switching over to an alum nozzle and the hole is threaded, so would like to know just how tight to make it...Thanks...
-
05-13-2008, 01:08 PM #2
I just do mine snug and same thing for the nut on the bottom.
-
05-13-2008, 01:35 PM #3
Steering cable joint – nozzle
deflector Nut 5.1ft/lbs
-
05-13-2008, 02:15 PM #4
I looked at that spec and saw that it was for the nut...Thanks...
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WTB Steering cable end (ball Joint)
By Water4fire in forum Sea Doo ClassifiedsReplies: 1Last Post: 09-04-2015, 09:20 AM -
steering cable joint
By Pale Rider in forum Yamaha Open DiscussionReplies: 9Last Post: 06-06-2009, 07:14 PM -
Extending the stock trim and steering cable for 2" exte
By Insanediego Joe in forum Yamaha PWC Performance (2-stroke)Replies: 17Last Post: 11-01-2007, 05:55 PM -
Steering cable and stock tube ....
By Flyer in forum 4-Tec PerformanceReplies: 7Last Post: 02-26-2006, 12:31 PM -
Steering Cable Tip
By 1FastTrespiper in forum Sea Doo Open DiscussionReplies: 1Last Post: 08-26-2005, 08:26 PM
Order the gasket set as well. Grease the gasket to aid with sealing
2004 gp1300