Results 1 to 5 of 5
Thread: Help with primer kit
-
05-12-2008, 05:15 PM #1
- Join Date
- Mar 2008
- Posts
- 82
Help with primer kit
im trying to install the body of the primer kit but im having problem removing the nut of the old one, can u someone tell me how to remove it ?
and where do i need to put those on the pic (include with primer kit) ??
Thanks
-
05-12-2008, 05:58 PM #2
- Join Date
- Aug 2006
- Posts
- 6,257
- +1
- 1
those go were the choke shaft goes thru the carb once you remove them
try cutting a 12 mm wrench in half and cutting some foam from the sidewall for better access
-
05-13-2008, 11:37 AM #3
-
05-13-2008, 05:51 PM #4
- Join Date
- Mar 2008
- Posts
- 82
the nut that hold the Fuel cock assembly
-
05-13-2008, 11:18 PM #5
Amine you do not need those brass parts on the carbs I sold you. you run the primer lines to the oil injection inlets remember I showed you. The choke shaft holes are already plugged. Cut the tee for your primer kit in the return line not the feed line.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
need help with primer kit
By Islandrida92 in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 06-25-2014, 07:37 PM -
Need help with C-KIT (low boost)
By elbchecker in forum 4-Tec PerformanceReplies: 14Last Post: 08-29-2008, 11:07 AM -
help with installing oil block off kit
By joshxp in forum Polaris Open DiscussionReplies: 4Last Post: 03-30-2007, 11:28 AM -
Help with RXT stage 1 kit
By chrisb370 in forum 4-Tec PerformanceReplies: 6Last Post: 07-04-2006, 08:14 PM -
Help with Riva air filter kit
By 818RXP in forum 4-Tec PerformanceReplies: 20Last Post: 08-19-2005, 06:59 PM
i sold the ski 4 years ago. I should of kept it, it was the most fun ski...
f15x engine in r12x hull