Results 1 to 4 of 4
-
05-09-2008, 03:36 PM #1
Reassembly of GP1300R jet pump (silicone needed???)
Quick question.
I changed the impeller on my 2003 GP1300R and I have a question on the reassembly of the jet pump. Is silicone required between the mating surfaces of the pump, ring liner, and nozzle. If so is 3M 4200 OK.
Thanks for the help
-
05-09-2008, 03:38 PM #2
Yes and I'd say yes. Only takes a small amount.
-
05-13-2008, 11:43 AM #3
its not required, when im in a hurry i dont silicone it.... but if you know your not changing the prop for a while than goop it up......
i wouldnt use 4200 there.... try some rtv silicone, its way easier to get apart later...
-
05-13-2008, 04:36 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Polaris genesis jet pump replacement need help
By chc3 in forum Polaris Open DiscussionReplies: 1Last Post: 07-12-2013, 10:46 AM -
300x jet pump inspection (need help)
By ange5583 in forum Kawasaki PWC Performance (4-stroke)Replies: 5Last Post: 02-21-2012, 07:07 PM -
Pics of removed jet pump/and help
By absolutesltx in forum Polaris Open DiscussionReplies: 8Last Post: 06-10-2010, 12:16 PM -
04 Gp1300r Fuel Pump Picture Needed
By gzk in forum Yamaha PWC Performance (2-stroke)Replies: 25Last Post: 01-01-2009, 09:39 PM -
Anyone have a pic of RXP jet pump support ?
By DaveC in forum Sea Doo Open DiscussionReplies: 8Last Post: 03-16-2008, 05:27 PM
Good deal. Glad you were able to work it out.
RXT tops out at 7600rpm