Results 1 to 2 of 2
Thread: Shot wear rings...
-
05-05-2008, 06:05 PM #1
Shot wear rings...
This seems to be a never ending battle...but i love it. I'm going to replace the wear rings on my 96XP and 95XP before full swing riding season for me. Is this as bad as it sounds like its going to be and do i need the anit rattle kit too? Input apprecieated. thanks all!
-
05-07-2008, 07:51 AM #2
- Join Date
- May 2007
- Location
- clearwater,fl
- Posts
- 68
its a pain but not that bad. I have done my 95 xp's you will need the inpeller removal tool its only like $10 another great tool to have is the seadoo alignment tool its like $150 but its a must have when doing motor mounts. If your engine is just slightly out of alignment it will lose power and eat up wear rings.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
TIP - Bar Extensions and Wear Ring Info
By MikeTrin in forum Sea Doo How To & FAQsReplies: 7Last Post: 06-19-2007, 03:05 PM -
stainless steel wear ring
By shortee in forum 4-Tec PerformanceReplies: 12Last Post: 06-18-2005, 09:36 PM -
wear ring damage
By INDY27 in forum 4-Tec PerformanceReplies: 18Last Post: 05-25-2005, 08:41 PM -
wear ring removal
By watermedic in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-18-2005, 09:12 AM -
wear ring
By nitro rxp in forum 4-Tec PerformanceReplies: 16Last Post: 05-12-2005, 05:58 PM
Just purchased RXP 215. All original. Instead go going down the typical...
N20 and prop change instead of...