WTB:Boarding Step: SLT SLH SLTH SLTX SLXH Virage TX

[woollums]

I need a step for my 02 Virage. I was told these models are the same. PM me if you have one you'd sell. SLT SLH SLTH SLTX SLXH Virage TX

[Bone1050]

http://greenhulk.net/forums/member.php?u=1532 jetskimn has a used one for 40 but doesnt have any hardware to mount i think i could be wrong pm him for details

[32DegH2O]

Thanks 97sltx1050 for the reference! Here's a pic of what I have, however I believe 800Amsoil is going to buy it...he contacted me this morning about it...just waiting to hear back. If he decides not to get it, obviously it will be available. Like my ad says, no hardware or install instructions, but both can be ordered and downloaded at the www.aquaperformance.com this is part 1096SLTX. This is brand new...was a display model.

Edit...step is sold.

[woollums]

Still looking

[Keddano]

I have one I may sell,Just have to check if it'll fit the MSX. Just got back home from Cali,Let me check tonight.

[K447]

I have one I may sell, Just have to check if it'll fit the MSX..

The MSX step is several inches narrower than the SLTX/Virage aqua-step.

The MSX step brackets lines up with the tiny X marks scribed into the small flat areas on the transom for the step mounting screws. On 2003 MSX hulls, there were aluminum reinforcement plates behind those marks.

Apparently the 2004 MSX hulls don't have the metal plates, so maybe the marks don't mean as much.

[woollums]

I have one I may sell,Just have to check if it'll fit the MSX. Just got back home from Cali,Let me check tonight.

Did you get a chance to check?

[Keddano]

Sorry,forgot,I'll check tonight

[Keddano]

The step is too wide for a MSX hull,would not sit on the flats. So yea,I'll sell it.It is a factory Polaris,foam and springs are good on it. It also has the angled contured blocks so it fits the hull correctly. This one was held to the transom with the hull inserts(Which you can by from Aqua-step or Mcmaster-carr) or you can drill and bolt thru the hull. Pm sent