Results 1 to 10 of 10
-
06-03-2006, 01:13 PM #1
Boost guage install port Question
What hole in the intake are you guys using???
The front Middle, or the Rear.....
To tap in for the boost guage
-
06-03-2006, 01:23 PM #2
- Join Date
- Jul 2005
- Location
- Lake Chickamauga/ Chattanooga TN
- Posts
- 954
Doesnt matter, same volume of air in each, but I used the middle because it looked the prettiest at the time
Jay
-
06-03-2006, 01:49 PM #3
I went in the front....just the easer to get to
Thanks for The info
-
06-03-2006, 03:20 PM #4
I also went with the front, heat up a nail the same size diameter of hole, and push thru, may take a few times...PR...
-
06-03-2006, 05:27 PM #5
I just used a drill bit that would fit and pull out the trash......
-
06-04-2006, 10:38 AM #6
Just curious as to why some would use the intake to get readings and not the block off plate? Seems to me you`d want the intake runners undistorted in the least amount.
-
06-04-2006, 12:06 PM #7
- Join Date
- Jul 2005
- Location
- Lake Chickamauga/ Chattanooga TN
- Posts
- 954
^stock intercooler=no block off plate. . .
Jay
-
06-04-2006, 12:24 PM #8
With a stock intercooler I really don`t see needing a boost gauge, unless to check to see if clutch is slipping.
-
06-04-2006, 12:33 PM #9
- Join Date
- Jul 2005
- Location
- Lake Chickamauga/ Chattanooga TN
- Posts
- 954
Correct again.
Plus the bling factor. . .
Plus more mods to come. . .
Jay
-
06-04-2006, 01:58 PM #10
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Boost Guage Install
By kc8lbn in forum Honda How To & FAQsReplies: 2Last Post: 12-29-2007, 05:20 PM -
Dynotune Boost Guage Installed
By DIGGS in forum 4-Tec PerformanceReplies: 18Last Post: 09-06-2007, 02:16 PM -
boost guage install question
By CarFanatic in forum 4-Tec PerformanceReplies: 16Last Post: 05-19-2007, 03:08 AM -
boost guage install
By brad2510 in forum 4-Tec PerformanceReplies: 21Last Post: 02-12-2006, 12:49 AM -
boost guage install
By brad2510 in forum 4-Tec PerformanceReplies: 2Last Post: 01-19-2006, 05:10 PM
I’m noticing that I’m getting a ~200RPM surging on idle. I can’t recall if...
Where Is My Coolant Going?