Results 1 to 10 of 13
-
05-01-2006, 09:39 AM #1
Installing Les Metal Clutch Washers
I am installing Les washers in my 05 RXT S/C. I have new spring washers, needle bearings, Les washers and RR shims in case the tension is not correct. My question is the final torque on the clutch stack and what the slip moment should be with the metal washers.
Also if you do not make the range of slip, where does the shims go, under the crush collar or between the spring washers? Thanks for any help and I think the original clutch was just a hair away from failing because the slip was around 60"lbs with the ceramic washers.
-
05-01-2006, 09:42 AM #2
Skip, you won't need the shims. The metal washers are thicker than the ceramics which puts more tension on the clutch.
You will probably be at about 16 nm, but after 4, or 5 hours of run time the slip moment will drop down to 12 NM.
by the way, the shims go in between the spring washers.
-
05-01-2006, 09:51 AM #3
Jerry, what is the final torque on the clutch stack in standard units? Someone ttold me 22'lbs. Thanks.
-
05-01-2006, 09:53 AM #4
Re: Installing Les Metal Clutch Washers
Originally Posted by skipSC
-
05-01-2006, 09:58 AM #5
Because I am out of warranty and even if I was still in, they would still install ceramics. And I prefer to do my own maintenance so I can understand my machine.
-
05-01-2006, 10:05 AM #6
-
05-01-2006, 10:09 AM #7
Skip, final torque on the nut is 22 ft lbs.
Don't forget to use red loc tite.
-
05-01-2006, 10:14 AM #8
-
05-02-2006, 12:45 PM #9
Jerry, Did you get my P.M. about washers.
-
05-02-2006, 01:47 PM #10
Yep, the manual says to torque to 22 Ft. Lbs. I stand by that.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
06-07 riva supercharger metal clutch washers for sale
By H2HO in forum Sea Doo ClassifiedsReplies: 4Last Post: 05-10-2009, 03:05 PM -
Metal Clutch Washer Failed ??!!
By Cdoo EtR in forum 4-Tec PerformanceReplies: 15Last Post: 05-28-2007, 03:27 PM -
SC Metal Clutch Washers NEW!
By Hydrogen in forum 4-Tec PerformanceReplies: 8Last Post: 05-22-2007, 04:09 PM -
For those waiting on metal clutch washers and skegs
By Green Hulk in forum 4-Tec PerformanceReplies: 13Last Post: 10-25-2006, 04:55 PM -
metal clutch washers
By Green Hulk in forum 4-Tec PerformanceReplies: 110Last Post: 04-07-2006, 01:24 PM
Hi, I have a 2000 Ultra150 with 95 hours on it with a rebuild done 10...
Ultra150 No start only clicking