How To: Making A Water Box Strap Installation-Removal Tool

[1FastTrespiper]

Using a 20" screwdriver cut 1/16" slot in the center of the blade with a hacksaw or cutting tool. Standing on the left side of the doo insert the notch of the screwdriver into the metal wire on the strap end. Push down and tilt the screwdriver back and the strap will come off. To install strap hook it on the metal of the strap, again push down with the right hand, with your left hand push back on the metal wire until it latches. Be careful not to stab yourself. You can still use this as a normal screwdriver too.

[rxpblast]

great idea!

[Pale Rider]

OK, now make a install tool ...PR...

very good Idea!

[Red Devil]

Nice idea and very creative!!!

[Totallyblown]

Or you could just do what i did...tok me about a 30 secs to get it off...Jay can vouch...LOL

[ramnj]

Also makes an excellent carburator adjustment tool on the GPR's.

[darrel]

I did this last night and I just used a small open end wrench for the job. Worked great after I thought of using it.

[eel]

I have had one for 20 yrs, almost identical. (great minds think alike! )

[HOSS]

I used my hand and arm.

[seadoor]

great idea