Results 1 to 10 of 32
-
04-23-2006, 09:10 PM #1
How To: Wire into the MPEM for switched power source.
well ive been promising some instructions so here they are
the small pins are number 278000995 there $2.00 a peice. (buy a extra)
follow the steps, it should take less then a hour.
-
04-23-2006, 09:24 PM #2
-
04-23-2006, 10:39 PM #3
You can get those clips from Napa in packages of 5 for about $3.
They also sell the rubber gromets that need to seal the back side of the plug as well.
Thanks for taking the time to post this!
-
04-24-2006, 09:15 AM #4
Thanks for the How-To. I made it sticky and moved it to the technical info forum.
-
04-24-2006, 12:50 PM #5
that is some great info and those pics really help out. THANKS!
-
04-18-2007, 11:31 PM #6
I have a purple wire on pin 25, also I can't find the pins at NAPA referencing that part number. Can I just tap the purple wire (what is it).
Thanks
Stevew
-
04-18-2007, 11:38 PM #7
u want 2-22... that is the empty spot for it... there's no female wiring pin in there at all... u gotta add one.
-
04-19-2007, 02:59 PM #8
Is there a fuse spot for 2-22? I did this, but I have no power on the line????
-
04-19-2007, 03:15 PM #9
Awesom job thanks for the great write up. Just cusrious I have an 04gtx/sc is this connector the same?
Thanks
John
-
04-19-2007, 03:18 PM #10
John... this write up Daniel did is actually WITH an 04 GTX SC motor and electronics. this is in his XPL 4-tec, and he used a 185 motor and electronics for the build.. so what u see here is exactly what u will see on your ski.
regardless, all the MPEMs are the same (except 2007) ... only variation is the options and fuse terminals that are being used or not
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
does anybody know how to wire the magneto into the terminal board
By H2ozone in forum Polaris How To & FAQsReplies: 1Last Post: 05-10-2015, 12:19 PM -
How to pull off the wiring harness of the ECU from a 2012 RXP-X?
By 800AMSOIL4U in forum 4-Tec PerformanceReplies: 6Last Post: 10-07-2012, 06:55 AM -
FS Electrical pins to wire into MPEM
By jhill19 in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-08-2012, 11:04 PM -
how to wire up a 3 way switch for bildge pump.
By jdy2kgt in forum Sea Doo Open DiscussionReplies: 4Last Post: 06-28-2009, 06:43 PM -
best place for switched power source finally
By excess in forum 4-Tec PerformanceReplies: 9Last Post: 07-15-2007, 08:49 PM
No water at all.
Unveiling the 2022 Kawasaki Ultra...