Results 1 to 5 of 5
Thread: milkshake in Cone
-
04-20-2006, 05:11 PM #1
milkshake in Cone
I know water that gets in the cone causes the milkshake but how does the water get in. This is the second time it has done it. It has the 2 o-rings in the side and I see a black o-ring at the bottom. After I took my cone off and flipped over the pump water dumped out.
-
04-20-2006, 05:58 PM #2
That happens a lot on my brothers 03 gtx/sc with the plastic pump, it's warped so riva is building him a metal pump. But you have the rxt it's metal so my guess is that you need to replace the seals in your pump. I had ppg install a solas in that 03 gtx/sc. I checked the cone mid season and noticed water so I sent it back to them and they fixed it. If impros installed your solas you could give them a call.
-
04-20-2006, 05:59 PM #3
Chances are the nose cone came off? Mine has done the same thing twice when the nose cone came off. The water forces it way through the prop and in the front from what I have seen. If your nose cone was on I have no idea!
-
04-20-2006, 06:19 PM #4
-
04-20-2006, 06:20 PM #5
Originally Posted by miketrin
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
how much grease should i put in cone of svho?
By macattack in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 06-24-2016, 04:46 AM -
Synthetic lube 80W / 90 for pump bearing (in cone 1/3 rd deep) vs standard grease
By lost_dogg in forum 4-Tec PerformanceReplies: 18Last Post: 01-22-2014, 08:38 PM -
Water in the pump cone and bearings...now what???
By RXP-REX in forum 4-Tec PerformanceReplies: 13Last Post: 06-23-2007, 07:36 PM -
do the rxps have oil in jet pump cone??
By CarFanatic in forum 4-Tec PerformanceReplies: 7Last Post: 06-05-2006, 06:19 PM -
Water in the cone fixed
By Kinchyle in forum Sea Doo Open DiscussionReplies: 2Last Post: 05-03-2006, 02:07 PM
I talked to Kawasaki CS again today. Was told they won’t have an answer...
Code 69 - Knock Sensor Malfunction...