Results 1 to 8 of 8
Thread: air/fuel gauge ?
-
04-17-2006, 08:38 AM #1
air/fuel gauge ?
Hey guys I would like to install on of these before I start my mods as I plan on adding a RR SC impeller with open air intake is this all I need and is this a good one?
http://www.dynotunenitrous.com/store...?idproduct=150
Thanks
Scott
-
04-17-2006, 08:45 AM #2
There are a couple of us here that use that exact same one. It works great!!
-
04-17-2006, 08:51 AM #3
-
04-17-2006, 10:03 AM #4
did you remove the J pipe for the bung install if so how hard was it to remove and reinstall
I think I will order their boast gauge also
Thanks for this site GH
-
04-17-2006, 10:06 AM #5
Originally Posted by shhr
-
04-17-2006, 06:03 PM #6
I took mine to my local welder, and cut the holes myself. They welded the outer shell to the inner shell, then welded the bung over the hole I drilled in the middle. came out great.
-
04-17-2006, 06:30 PM #7
dynotune has stainless bungs too, might have to ask for it.
-
04-17-2006, 10:59 PM #8
thanks guys
I needed that picture, is the pipe water cooled at that point for some reason I thought the bung needed to be installed on the pipe before it is water cooled
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
For those of you using Innovate air fuel gauges
By Green Hulk in forum 4-Tec PerformanceReplies: 10Last Post: 03-02-2009, 02:07 AM -
Air/Fuel gauge readings
By Bamafanatic in forum 4-Tec PerformanceReplies: 0Last Post: 05-07-2007, 08:30 AM -
air/fuel gauge installed
By shhr in forum 4-Tec PerformanceReplies: 30Last Post: 03-10-2007, 05:01 PM -
wiring the air/fuel gauge
By shhr in forum Sea Doo Open DiscussionReplies: 2Last Post: 06-01-2006, 09:57 PM -
Air/Fuel Gauge setup
By Kinchyle in forum 4-Tec PerformanceReplies: 23Last Post: 04-12-2006, 08:54 PM
I said "better" not good or trustworthy I do not have any kind of business...
Remove an ECU tune?