Results 1 to 4 of 4
Thread: Hose Clamps
-
04-02-2006, 05:57 PM #1
Hose Clamps
Seen these at Home Depot today. Take note of rounded edges, E-Z'r on hose
-
04-02-2006, 06:29 PM #2
Those look good, looks like they won`t bite into the hoses...
How much?...PR...
-
04-02-2006, 08:54 PM #3
I don't know price right off hand. Will look and post.
-
04-03-2006, 09:08 AM #4
They won't go up to 3 inches though.
I made mine using JB Weld. Just get a normal screw clamps and add a ball of JB Weld to the end of it. Make sure to get the JB Weld in the slot on the screw and don't get it on the spinning part of the screw or it will be locked.
I use it for my rear intake so I can secure the vent after I slide on the rear bucket. Then I can take off the vent and rear bucket on the water.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Ride Plate Wire hose clamps...
By Pale Rider in forum Sea Doo Open DiscussionReplies: 5Last Post: 09-24-2008, 01:57 PM -
Hose clamps on stock intercooler??
By Snoman in forum Sea Doo Open DiscussionReplies: 2Last Post: 12-21-2006, 01:39 PM -
Damn hose clamps!
By RedlineR6 in forum Polaris PWC PerformanceReplies: 6Last Post: 08-29-2006, 05:44 PM -
Possible hose clamp replacement?
By Jarrett in forum Sea Doo Open DiscussionReplies: 5Last Post: 05-12-2006, 05:57 PM -
Hose Clamps !
By RX951 in forum Yamaha How To & FAQsReplies: 0Last Post: 04-29-2006, 03:40 PM
I read, before the pandemic, dealers would gift the customer. I thought...
Unveiling the 2022 Kawasaki Ultra...