Results 1 to 3 of 3
-
08-09-2007, 02:09 PM #1
how hard is it to pull a head on a 4-tec?
how hard is it to pull a head on a 4-tec?
i have a plug that a lil darker than the rest i think it might be a burnt exhaust
valve. and only 125 psi comp in that cyl.
-
08-09-2007, 05:13 PM #2
- Join Date
- Jun 2005
- Location
- rome ga
- Posts
- 936
- +1
- 20
Is it hard to start? It's not real hard to pull the head. Realignment of the cam to crank is a little tedious. Search past threads.
-
08-09-2007, 08:34 PM #3
before you pull the head try a leakdown test..
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How hard is it yo pull out the Jet Pump on a 300x to inspect bearings
By rod_rod in forum Kawasaki How To & FAQsReplies: 12Last Post: 06-04-2016, 07:57 AM -
How hard is it yo pull out the Jet Pump on a 300x to inspect bearings
By rod_rod in forum Kawasaki PWC Performance (4-stroke)Replies: 12Last Post: 06-04-2016, 07:57 AM -
How hard is it to instally a clutch on a Supercharged Yamaha?
By CARLRRE in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 10-01-2014, 06:47 AM -
How hard is it to remove the supercharger ?
By Ultra250xryder in forum Kawasaki PWC Performance (4-stroke)Replies: 3Last Post: 09-27-2007, 09:39 PM -
How Hard Is It To Rebiuld My Engine?
By jsc7002 in forum Polaris Open DiscussionReplies: 10Last Post: 06-15-2007, 01:37 PM
Made a new topic, but I found something odd. It seems a non resisted plug...
No spark after 3 mins or so run...