Results 1 to 2 of 2
  1. #1

    How many hours for skat modded pump?

    how many hours should the skat modded pump last?

    I always check for water intrusion, found 2 instances, one when rocks killed the prop, and just now there were a few droplets in the front bearing. everytime I crack open the pump I see gun powder type stuff in the oil. spins freely, what is this and where does it come from?...

    I did notice that the housing looked a bit dark on the end bearing, but this could have been from the original maybe!? or these bearings are spinning in the bore? I do have radial play, can`t measure it precisely, but I have easily .008 blade clearance normally and if you push on one side of the shaft the .008 is loose, you could jam in a .009 gauge but you could see it`s tight...PR...

  2. #2

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How many hours for a dealer to pull a engine and clean it
    By travis ingram in forum 4-Tec Performance
    Replies: 16
    Last Post: 07-01-2014, 01:02 PM
  2. Rebuild SC at how many hours for 2012 Yamaha FZS and rebuild motor or other issues??
    By williamsrt in forum Yamaha PWC Performance (4-stroke)
    Replies: 6
    Last Post: 09-12-2013, 07:29 AM
  3. Curious - @ how many hours to quit modding/investing $$ ?
    By blkturbo! in forum Sea Doo Open Discussion
    Replies: 11
    Last Post: 11-16-2011, 11:19 AM
  4. how many hours is too many for rxp sc
    By abarrassr07 in forum Sea Doo Open Discussion
    Replies: 8
    Last Post: 03-02-2009, 10:15 AM
  5. How many hours is the carbon ring good for?
    By Mark S in forum 4-Tec Performance
    Replies: 9
    Last Post: 03-02-2008, 12:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts