Results 1 to 4 of 4
Thread: copper spray
-
08-03-2007, 12:31 PM #1
copper spray
Hey all,
When you use Copper spray on gaskets, do you let it set up for a while, or build while it it still wet
Sean
-
08-03-2007, 12:46 PM #2
I wait for it to go off a bit and then put it together .Dont want it to get on the cylinder walls if it compresses out .
Cheers
Bernie
-
08-03-2007, 12:49 PM #3
-
08-03-2007, 01:24 PM #4
I prefer to let it tack, but I have used it both ways with the same results.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
So USE or NOT to use the Copper spray
By sea-one in forum 4-Tec PerformanceReplies: 7Last Post: 06-30-2013, 10:25 AM -
Copper spray for headgasket?
By camar0 in forum 4-Tec PerformanceReplies: 6Last Post: 04-14-2010, 08:26 PM -
Heads up on using Copper spray
By fullboogie in forum Yamaha PWC Performance (2-stroke)Replies: 29Last Post: 04-13-2009, 10:31 AM -
Spray Painting Grab Handle
By MartyRXP in forum 4-Tec PerformanceReplies: 9Last Post: 11-21-2008, 10:21 AM -
Re-Using Head Gasket and Copper Spray
By DrewNJ in forum Yamaha Open DiscussionReplies: 10Last Post: 12-20-2007, 12:46 AM
The spark plugs were good, no damage they were brand new only ran for the...
Ultra150 No start only clicking