accessory wire?

[nitro rxp]

I looked at rxp wire diagram and it shows the fuse block has a spare accessory 5 amp fuse. It suppies power when the key is on. I think this will be a good place to wire up the fan for the ppg air intake mod without always have to turn a switch on and off all the time. But the diagram dont list which wire is the output off this fuse. Does anyone know which wire it is?

[nitro rxp]

Thanks alot guys, you could of save me alot of trouble if you told me their was no accessory wire that came out of the harness. I ohmed out the pins to find the right one. I found it! But the harness that plugs into it dont have a wire for that pin. I just need to add a wire to the harness then I will be set to run the fan that turns on when the ski is on.

[rapidacceleration]

INSTALLING PINS IN THE PLUGS ARE EASY. they are avalible at your local dealer for 1.97 each. the modual plugs come right apart, pass the wire threw the back plug,rubber,etc before you crimp it, then press it into the plug. i think the pins your looking for are 2-22 (fuse2) and 2-25(fuse. I hadda do the same when i installed my depth transducer.
ive got the complete shop manual on cd if you need a copy email me.

[Kinchyle]

I'm looking to do the same thing. I have a battery monitor light and a 4.4 attwood fan (4.4amp).

I have no idea what yall are talking about with "pins in the plugs".

Is there a manual that describes this type of install. I purchased the 05 seadoo repair manual but haven't look through it yet.

I'm just wanted to be able to hook up the fan and have it switch on when I either hook up the lanyard or power up the ski.

Also would like to do the battery monitor light and boost guage too.

[BoostedH23a1]

INSTALLING PINS IN THE PLUGS ARE EASY. they are avalible at your local dealer for 1.97 each. the modual plugs come right apart, pass the wire threw the back plug,rubber,etc before you crimp it, then press it into the plug. i think the pins your looking for are 2-22 (fuse2) and 2-25(fuse. I hadda do the same when i installed my depth transducer.
ive got the complete shop manual on cd if you need a copy email me.

anyone have a part number people in SC dont seem to know things.