Results 1 to 1 of 1
Thread: Front Engine Mount Surface Crack
-
07-27-2007, 01:55 PM #1
- Join Date
- Jun 2006
- Location
- toronto
- Posts
- 965
Front Engine Mount Surface Crack
Was probably like this for a while but when getting a few mods done to my little 96XP we found a surface crack on the inner hull front engine mount area. There is no movement when putting pressure on the pipes eg. the engine is still in there hard and does not move under pressure. Here's my question...Has this happened to anyone else? And, is it a pretty safe bet to just ride it until the seasons over and then get the work done? I would imagine Jay was wave jumping and cracked it, but probably didn't notice because it still sits in there flush and firm.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Solid front engine mount
By VX1 in forum 4-Tec PerformanceReplies: 2Last Post: 07-10-2007, 05:30 PM -
Solid front engine mounts only $169
By Green Hulk in forum 4-Tec PerformanceReplies: 44Last Post: 04-16-2007, 06:06 PM -
Rotax Racing front engine mount
By 01xdime in forum 4-Tec PerformanceReplies: 13Last Post: 09-11-2006, 09:39 PM -
Front Engine Mount vs. Triple Bearing
By Kinchyle in forum Sea Doo Open DiscussionReplies: 29Last Post: 06-13-2006, 01:29 AM -
RR Front Engine mount
By terryt in forum 4-Tec PerformanceReplies: 3Last Post: 02-28-2006, 10:28 AM
I'd start by checking the fuses on the MPEM. Had a 5A go bad on a GTX a...
Seadoo GTI LE issues