Results 1 to 2 of 2
  1. #1
    mrbtd's Avatar
    Join Date
    Jul 2005
    Lindenhurst, Illinois, United States

    How to replace bumpers

    I have plans on ordering a new set of bumpers and the inner pieces/corners for my GPR.

    When I did my HydroTurf mats I had a problem on the rear where the plastic flat spotted about 3" I am thinking it is because the rivets supplied were to large ?

    Is there a way to stop that from happening ?

  2. #2
    Never say never KirkF350's Avatar
    Join Date
    Jun 2005
    Colleyville, Texas
    I bought some s/s bolts with the nylon nuts. The bolts were flat head phillip screws. You can not go back with the small black "pin" type covers, but I think it still looks ok. They have been on like that for 5 years.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to replace hood latch?
    By johnsonmtz in forum Polaris Open Discussion
    Replies: 4
    Last Post: 07-06-2020, 10:35 PM
  2. How to replace rivets holding rear bumper pad on 2008 STX-15F
    By Western NC in forum Kawasaki How To & FAQs
    Replies: 5
    Last Post: 04-30-2013, 08:17 PM
  3. How To Replace a Plastic Pump Liner
    By RX951 in forum Yamaha How To & FAQs
    Replies: 24
    Last Post: 04-30-2010, 07:54 AM
  4. Any one know how to replace bad diode in MPEM
    By Pete-n-sara in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 10-30-2007, 08:42 PM
  5. How to replace trailer bearings
    By antoniodef in forum Polaris Open Discussion
    Replies: 9
    Last Post: 05-14-2007, 03:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts