What hose goes to the water bypass?

[GeoRXT]

And besides the riva hole that needs to be plugged, any other needs to be plugged?

[Green Hulk]

There is a hose that goes from the bottom of the exhaust manifold to the bottom of the J pipe. This hose has a Tee in it and the Tee'd off line normally goes to the exhaust outlet fitting. This is the line you want to run to your bypass.

[seadoor]

what its the performance

[Muddy River]

And besides the riva hole that needs to be plugged, any other needs to be plugged?

Geo: Keep at it! You will be an expert on this motor in no time!

[Green Hulk]

what its the performance

None, it just looks cool squirting out the side of your hull

[HOSS]

I blocked off the t. I was going to run a pressure gauge but said phuc it.

[GeoRXT]

But I never plugged that tee'd hose when I took the stock exhaust out, or the RR one....I will check tomorrow and post back. I know there is a tee fitting there I just dont know where its going....

[GeoRXT]

This hose is connected to a fitting in the pump, so I guess it goes out that way. I will work on it when I get back next week. Gotta take the intercooler out again to be able to cap the fitting shut.

[05Limited]

Geo... you're right. On an RXT the water from the tee is dumped through the pump housing. In an RXP it dumps at the end of the exhaust pipe.

Don't know why the difference, though

[GeoRXT]

Im guessing its that stream of water that comes out through the back when you flush it...?