Results 1 to 6 of 6
-
07-09-2007, 11:57 AM #1
Clearance between wear ring and prop?
how much do you guys charge to have this edge re-welded i guess you would call it, i have a stainless ring and he prop is worn down.
-
07-19-2007, 12:47 AM #2
That's what we call the "Worx", we verify/correct the blade pitch, weld the impeller's diameter and machine it to fit the wear-ring, and refinish and balance it for $89.00. Some impeller prices slightly vary, but this is typically the price. We have them for about 4 days right now.
Thanks
David
-
07-20-2007, 12:35 PM #3
-
07-23-2007, 09:43 PM #4
Not necessarily. We know what size to machine them to fit the rings, but there are always slight variances. If you want it as tight as possible, you can measure it with good calipers if available, or send us the pump. We'll only have the parts a day or two.
Thanks
David
-
07-24-2007, 07:20 AM #5
banging, might have to wait till i find a spare pump...dont want any down time ya know....
-
07-26-2007, 09:55 AM #6
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
1996 seadoo gtx pump issue ( gap between wear ring and prop)
By mito lete in forum 2-Stroke PerformanceReplies: 5Last Post: 05-23-2013, 01:49 PM -
FS - Parts SOLD! 162mm Wear Ring and Prop for FZR
By 64physhy in forum Yamaha ClassifiedsReplies: 1Last Post: 12-07-2012, 09:28 PM -
wear ring and prop question
By bigmikers6 in forum 4-Tec PerformanceReplies: 5Last Post: 04-03-2008, 09:46 PM -
Rock vs wear ring and prop
By bruinsrme in forum Sea Doo Open DiscussionReplies: 3Last Post: 09-01-2007, 07:15 PM -
New wear ring and prop straightened
By kndtenn in forum Sea Doo Open DiscussionReplies: 5Last Post: 09-01-2007, 08:29 AM
I have recently bought a yamaha gp1200r, my family enjoyed it on the lake...
Gp1200r push start button get the...