Impellar Removal (CONE)

[brad2510]

When i removed my pump the little cone that screws on to the impellar had come unscrewed. I can't just pull it of the the shaft. I am never that lucky. Has any one had this problem? How did you resolve it? Any suggestions.


Second Question what do you use to lossen the impellar on the opposite side of the spline tool. first picture

[Green Hulk]

Grab it and pull hard!

[Top banana]

why cant you just pull it off. ive done about six skis...

[brad2510]

ill try that thing is tight.

[mxl16]

Second Question what do you use to lossen the impellar on the opposite side of the spline tool. first picture

i think its a 12mm allen

[Top banana]

When putting it back use an o ring to go over the threads and some loc tight and really work it tight. the trapped o ring helps keep it there..

[Green Hornet]

I've had mine come off. I greased the area where the driveshaft connects to the impellor and put red loctite on it. It came off again and this time I am going to put alot more loctite and sililcone the whole thing.

[Top banana]

use the o ring it works......

[brad2510]

putting the green cone on the impellar extremely had to tighten. Is everyone like that?

Were do you get a 12mm allen to take off the impellar can't find one anywere

[Pale Rider]

putting the green cone on the impellar extremely had to tighten. Is everyone like that?

Were do you get a 12mm allen to take off the impellar can't find one anywere

I found mine at AutoZone auto parts. sears will have regular 12mm allen wrench, you`d have to put a small pipe or hold that in the vice or something...PR...