What mod to do next?

[ventrj]

I have a 2006 rxt, with a blow off valve and a intake. I was wondering what would be the next best mod to do, i was looking at the intake grate or the pump wedge or the impeller. Any thoughts would be appreciated?

[ventrj]

please anyone

[shhr]

how much you want to spend

[ventrj]

For right now 250 to 300 or so

[shhr]

well one more question, do you plan on doing more mods in the future also what intake do you have Riva or home made

[ventrj]

I have the riva intake. About the other up grades i want to finish the stage one after that is complete i do not know if i will keep going

[cbrich]

Wedge, Riva Rear Exhaust, and Intake grate. After that remove the remove riva air intake and install a 4" intake, this will have to be homemade.

And don't forget the metal SC washers, this should be the very first mod.

[ventrj]

sweet thanks for the advice

[shhr]

in that case I would find a used RR sc wheel and get those ceramic washers out NOW

the SC wheel and washers will cost a little more than 300 but this mod will also have you needing a different prop

or you can add the wedge and a set of skeggs also remove the OPAS for around 250

and if you get the stage one prop 14/17R ( used for $170-200 ) you may have to send it to Jerry to be tweaked ( $50 ) so your RPM`s will be at 8100 ( I just did this mod to a friends RXT air intake and 14/17R after Jerry tweaked the prop it ran a best 67.4 )

[ventrj]

what is a RR and which sc wheel also what are skeggs and where can i find used parts. Also i can already hit 8100 rpms