Need some graphics

[lawracing]

Anyone know where I can get some graphics for my RX, I need something under the front cowl.

[joeg]

Check this site out. It is owned by a guy who goes by the name "ratfink" on sdn. I have purchased from him and can only say praises about his work. I know there are others out there that would vouch for him. He will also make custom decals for you if you like. http://www.pwcgraphics.com/

[watermedic]

I agree. PWCGraphics is the place to go. Mike is great to work with.

[RXP19]

I dont know about that! Every time I email him he never responds I called and e-mailed he must be to busy or something

[11]

Forget about whatever fools who post on SDN, whatever.

People just go there for the same reason they buy gator mats, they just don't know better than whatever is supposedely predominant in the small seadoo owners circles that modify their skis, lead by some notorious "guru".

Step into the real world of PWC aftermarket.

www.exoticsigns.com isn't the best place to go, it's the only one.

[Rendog]

I dont know about that! Every time I email him he never responds I called and e-mailed he must be to busy or something

I had a problem at first with contacting him also. But after I gave up emailing him I called him and the guy was great to work with, great registration numbers he made for me!

[lawracing]

Thanks for the links, I don't think the pre-made kits that I looked at will work but I will contact them and see if they can help. I bet they can make what I need. My ski is actually an rxp if you look close, I want to cover up the holes from the original trim. I'm going for the RX look (RXP in sleeper trim).

[Rendog]

Thanks for the links, I don't think the pre-made kits that I looked at will work but I will contact them and see if they can help. I bet they can make what I need. My ski is actually an rxp if you look close, I want to cover up the holes from the original trim. I'm going for the RX look (RXP in sleeper trim).

Man I htought that WAS a RX!

[WildBill9000]

My friend can make pretty much anything you can think of. Cheap too. He also has a little CNC mill if anybody wants any custom parts (GPS mounts?) made.

We made the graphic below for my cap. We are also making numbers to match the Sea-Doo logo (red with chrome outline)

[SuzanGPR]

Looks great WildBill! Seems to be like he does a great job. Thanks for the advice!