RXP Handling for 2006

[Jarrett]

Has anyone come up with a way to make these things take a corner better? I've just got the Worx sponsons and PPG Block offs on right now. I've got a set of the Riva Pro-Series in a box somewhere, but haven't installed them yet. Anything else out there to improve this area?

[Top banana]

R&D sponsons top nob for turns

[rxpblast]

a ride plate extension will also help out with this. i know a couple of guys have done this with good results. Jerry (GreenHulk) is one of them and there are some pictures on the forum of them. Just use the seach box and type in ride plate extension.

[nickdog]

Use R&D sponsons, R&D scoop grate, ride plate extension and opas block offs and it should be good. worx sponsons suck.

[jawz]

Sponsons do not make a boat turn... They keep it from kicking out.... Turning is a balance between the nose down and the nozzle pushing the ass end around... Drive a fork lift and then post...

[rxpstan]

Jawz forklifts don't lose the rear end when turning at speed.
The front end seems to dig in on both when turning.
Both are heavy.
But why does the RXP try to bounce at speed?????????

[dre23]

R&D sponsons top nob for turns

Are these R&D sponsons better than Riva sponsons? What is the difference?

[nickdog]

R&D sponsons are better than riva sponsons.

[jawz]

Stan, If your bouncing you either don't have enough ASS.... or it's in the wrong place.....Oh Another option Stan... Trim down

You apparently did not watch me drive a forklift

[buddydoo]

I'm getting a 3/4 extension welded on my ride plate this week and I hope it stops most of the bouncing at top end.I wish my rxp would turn like my rx I sold for the rxp.