Results 1 to 10 of 19
Thread: 785 Revs on trailer not in water
-
07-04-2007, 11:05 AM #1
785 Revs on trailer not in water
Just picked up this over the weekend. Runs fine on the trailer, in the water it is a slug. I noticed the PTO cylinder seemed to be cold as the MID and MAG cylinders would heat up when running on the trailer. I removed the carbs and found that the reeds for the PTO cylinder had a gap where the others did not. Could this be the problem?? I have spark and 180 Lbs of compression thru the cylinders.
-
07-04-2007, 11:39 AM #2
a gap...shouldnt be a gap.....can u take a pic?.....also 180 psi=race gas .......describe what u mean by a SLUG....is it slow? no power at all? take off ok then goes slow?? be alittle more specific..thanks
-
07-04-2007, 01:36 PM #3
Yes, race gas is run. My max RPM in water 5800. Will not rev in water.
-
07-04-2007, 01:53 PM #4
oh 5800 ok lol....have u checked to see if the valves are opening all the way?
-
07-04-2007, 02:41 PM #5
unplug the actuator and do this
-
07-04-2007, 02:59 PM #6
Valves open. I have done these checks and are looking into other problems. If it is not the reeds, i am assuming i have a leak in the exhaust that is causing the problem.
-
07-04-2007, 03:01 PM #7
didnt know you have done all those checks before......reeds shouldnt be open....problem 1...but i dont think its your rpm problem...i would look for an exhaust leak like u said.
-
07-04-2007, 04:35 PM #8
-
07-04-2007, 05:30 PM #9
and are u gettin spark on ALL 3 cylinders....5800 sounds like 2.when it should be 77-7800
-
07-04-2007, 06:01 PM #10
Pro 785
You may want to check the timing. If you have spark in all 3 cylinders and everything else looks good.. It may be time to replace the flywheel key...
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Runs good on trailer,dies in water.
By rmk-king in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 11-09-2015, 04:23 AM -
00 yahmaha xl 700 runs on trailer but not in water ...wtf??? any ideas?
By keefoism68 in forum Yamaha Open DiscussionReplies: 7Last Post: 07-31-2010, 07:10 PM -
1995 waveraider 1100 runs on land or hose but not in water
By mularski2 in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 07-13-2010, 01:32 AM -
98 XPL runs on trailer not in water
By JonnyRXT in forum 2-Stroke PerformanceReplies: 9Last Post: 09-18-2009, 04:50 PM -
96 sl 900 revs good on trailer not in water
By turbogn in forum Polaris PWC PerformanceReplies: 1Last Post: 07-24-2009, 10:50 AM
My clutch went out yesterday at 50 Hours, new 2021 Style Clutch, OEM Wheel...
Any one have issue with new style...